INSTALLING THE HOUSING (KIT6P)
1.
Mount the bracket.
Feed the cables through the mounting bracket
(X)
. In
case it is
needed, it is possible to remove one of the slot
covers
(Y)
on the mounting bracket to provide an
additional cable entry. Fix the bracket to the mounting
surface. Loosen the screw
(A)
and unscrew the two
screws
(B)
with a 4mm Allen key. For an easier access to
the screws
(B)
push the sunshield forward.
2.
Open the housing.
a. Slide forward the housing body.
b. Disconnect Earth cable.
c. Feed the cables inside the swivel joint.
d. Fix it to the bracket with screw
(C)
and nut
(D)
.
e. Pierce the needed fairleads
(E)
. Two Ø7-9 cables
fairleads and two Ø9-12 cables fairleads are available.
Feed the cables through the fairleads. Tighten the screws
on the two plates
(F)
3.
Electrical connections.
Install the camera with the provided screw and insulating
washer. Perform the electrical and video connections
according to the instructions in the camera installation
manual.
4.
Close the housing.
Adjust the housing position and tighten the screws
(C)
and
(H)
with a 6mm Allen key to fix it. To close the
housing connect back Earth cable, slide back the body in
its original position and tighten screws
(B)
and
(A)
.
5
