INSTALLATION
INSTALLING THE CAMERA
1. Extract the rear flange by removing the four
screws and the corresponding washers. Be
careful not to lose screws and washers.
2. Prepare the housing to install the camera,
sliding the upper rail away from the lower rail.
3. Install the camera on the upper rail using the
one of the ¼'' screws supplied, the plastic
washer and one or more spacers to be put
under the camera to adjust its height position.
Then slide the upper rail back on the lower rail
into the housing. Perform the electrical and
video connections. Cable glands are situated at
the bottom of the housing near the rear flange.
Eventually close the rear flange.
4. Use the screws at the bottom of the housing to
fasten the housing to its apposite support.
Issue 2 01/04/2008
Before performing any operation, turn off the power.
Only qualified personel can perform electrical operations
according to the regulations in force
Prior to installation and operation, read carefully this
manual of instructions
