Tecnosicurezza DigiTech Series, Руководство по установке

Страница: 7 / 20

II_DigiTech_01_eng 7 of 20
Installation instructions
DigiTech

Lock must not be lubricated.

In the locked position, the distance between the bolt and the boltwork part that is
moving the lock bolt must comply with the following specifications for each type of lock.

Any component to be fixed to the lock bolt must be previously approved by Tecnosicurezza
before installation. In any case, the maximum load must not exceed 2.5 N.

Secure the cables away from moving parts by using cable ties and cable ties bases.

If placed in normal domestic or office environments, the locks do not require particular
maintenance; in any case, after 10,000 opening/closing cycles, it is recommended to run
a test that verifies the correct and complete operation of the product.

Use only DURACELL™ 9 Volt Alkaline batteries, or battery holders with DURACELL™ 1.5
Volt Alkaline batteries. Alternatively, it is also possible to use a stabilized 12V - 1A power
supply (p.n. N1212) with relative power supply interface (p.n. T6005/W or p.n. T6005).

A series of acoustic signals during opening indicate a low battery level. In this case, the
battery must be replaced.
Keypad dimensions