![Tecnolec TL115SL-U Скачать руководство пользователя страница 7](http://html.mh-extra.com/html/tecnolec/tl115sl-u/tl115sl-u_instruction-manual_1071959007.webp)
Storage of fresh food in the refrigerator
Food should always be covered tightly with foil, plastic film, placed in bags or stored
in airtight containers. This will prevent food from dehydrating and prevent the strong
smell of some foods transferring to milder ones.
To store raw meat wrap in polythene bags or airtight containers and place on the
lowest shelf.
Do not allow raw meat to come into contact with cooked foods. For safety, only store
raw meat for two or three days. Fruit and vegetables should be thoroughly cleaned
and placed in the vegetable/ salad bin.
Milk and other liquids should be sealed with lids and placed in the bottle shelf on the
door.
Refrigerator defrost process
The refrigerator defrosting process is carried out automatically every time the
compressor stops.The defrost water drains from the cabinet into a tray placed on the
top of compressor to the rear of the unit where it evaporates.
Cleaning and maintenance
Before any cleaning or maintenance is carried out you must disconnect the appliance
from the mains supply by removing the plug, never remove the plug by pulling on the
mains cord. Remove the plug by pulling on the plug itself. It is recommended that when
clearning the appliance, both the inside and outside, can be cleaned using warm water
and a little bicarbonate of soda. Use 1 teaspoon to 1.2 litres of water.If the appliance is
to be used for a long period of time then it is recommended to remove all the food stuff,
clean the inside of the appliance and leave the door open to allow the air to circulate
thus avoiding unpleasant odours.
Changing the light bulb
Note.
Light bulbs are not covered by the warranty.
Turn the thermostat to the off position (0)
and disconnect from the mains. Push the clip at the base of light to the rear to release the
lamp cover. The Lamp is located in the back of the thermostat housing, unscrew the lamp
in an anti-clockwise direction until the lamp comes out of the lamp fitting.Screw a new
10 Watt (E14 Base) lamp into the lamp fitting in a clockwise direction until tight. Replace
the lamp cover back into position and click back into place. Set the thermostat to your
preferred setting and close the door.
If the appliance is not operating correctly:
Please check the following points.
Is there a power failure? (Check by turning on a house light)
Has the fuse blown or has the circuit breaker tripped?
Has the door been closed correctly?
Check the thermostat has been set correctly.
Check the mains plug seated in the wall socket correctly and the socket switch is on.
6