Electric Oven rev. 6 ______________________________________________________EKF 1021 UD – EKF 621 UD
_________________________________________________________________________________________ page 15
Possible faults
Type of fault
Cause
Corrective action
Control panel
completely off (the
oven does not work)
-
Incorrect electric connections to the mains
-
Check the mains connection
-
No mains voltage
-
Restore mains voltage
-
Thermal break safety device tripped
-
Reset the thermal break safety device
Cooking cycle set: the
oven does not work
-
Door open or ajar
-
Close the door
-
Damaged door microswitch
-
Contact a qualified technician to repair
the sensor
Automatic humidifier
ON: no steam is
produced in the
cooking chamber
-
Incorrect connection to water mains
-
Check the connection to water mains
-
Cut-off cock closed
-
Check the cut-off cock
-
Blocked water inlet filter
-
Clean the filter
-
Damaged water inlet solenoid
-
Contact a qualified technician to repair
the solenoid
Door closed: steam
comes out of the seal
-
Seal not fitted correctly
-
Check the seal fitting
-
Damaged seal
-
Contact a qualified technician to repair
the seal
-
Handle prong loosened
-
Contact a qualified technician to repair
the prong
The oven does not
cook evenly
-
One of the motors is blocked or turns
slowly
-
Contact a qualified technician to repair
the motor
-
The motors do not go into reverse
-
Contact a qualified technician to repair
the motor
-
Heating element not powered or is
damaged
-
Contact a qualified technician to repair
the element
Lighting lamp in the
cooking chamber does
not work
-
Damaged lamp
-
Change the lamp
-
Damaged lamp feeder
-
Contact a qualified technician to repair
the feeder
The thermo safety
device turns on in
continuous
-
Device damaged
-
Contact a qualified technician to repair
the feeder
-
Regulating thermo state damaged
-
Contact a qualified technician to repair
the feeder
11. Technical service
Before leaving the factory, the appliance was completely regulated and tested by expert
specialised personnel to guarantee the best operating results.
All repairs and settings must be performed with utmost care and attention, respecting national
safety regulations in force. Always contact your retailer or our nearest Service Centre, giving
details of the problem, the appliance model and the serial number (on the rating plate on the
rear panel). For any maintenance the user can contact Tecnoeka by calling the telephone
numbers on the cover or going to
www.tecnoeka.com
.
12. Informations to the consumers
Further to Directive 2012/19/UE, the symbol of the crossed rubbish skip on
the appliance means that at the end of its life, the product must be disposed
of separately from the other rubbish. The user must hand the appliance to a
specialised waste collection centre for electric and electronic equipment.
The separate collection of the rubbish and subsequent treatment, recovery and disposal help to
produce other equipment using recycled materials, reducing the negative effects on the
environment and public health, which would be caused by incorrect management of the
rubbish. Should the user dispose of the product abusively, administrative sanctions would be
applied
.
