TECHWOOD TTS-03, Инструкция по эксплуатации

Страница: 10 / 14

Place the largest, attachment comb onto your clipper and start by trimming the
sides from the bottom upwards.
Hold the clipper lightly against the hair with teeth of the attachment
comb pointing up but flat against the head.
Slowly lift the clipper up and outward through the hair, cutting only a
small amount at a time.(Fig. 1)
Repeat around sides and back of head.(Fig.2)
If you desire shorter hair, either change to a lower number attachment
comb or apply more pressure and less lift away from head with the
present attachment comb.
This entire procedure requires practice, and it is always better to
leave too much hair the first few haircuts.(Fig.3)
For the top of the head, you will give a fairly short cut if you use the
smaller comb. With the teeth flat against the head, slowly start
trimming from the front to the back. Again, it is better to leave the hair
longer the first few haircuts. (Fig.4)
Outlining
Outlining requires no attachment. Take the clipper and push the lever
up to the close-cut position.
Comb hair into the style. Position clipper between the side burns and
the ear. (Fig. 5)
Make sure the comer edge of the blade is against the hairline. With
the outline of the hair as your guide, slowly move the clipper over,
around, and behind the ears. (Fig.6)
For the back of the neck and the sideburns, hold the clipper upside down,
(see sketch), and holding it against the skin at the length desired, move
downwards.
Short cuts to perfect flat tops, crew cuts
Always cut from the back of the neck to the crown, using the
longest attachment comb. Holding it flat against the head, slowly
move the clipper up through the hair.
Use the same technique for the sides, cutting from the bottom to
the upper side of the head. (Fig.7)
For the front to the crown, cut the hair against the direction in
which it grows. Then even it up with the sides. (Fig.8)
For a flat top, use a flat comb, not the attachment comb. Just cut
hair on top of the head over it.
10