7
ASSEMBLY
1 bowl and splash-proof wall
2 Turntable
3 Base of the device
4 On / Off button (I / 0)
5 Spoon for mixing
To secure the turntable
, push down on the rod and make sure that the grooves
are properly aligned in front of the pins on the rod.
To secure the bowl
, gently push the bowl down and turn counter-clockwise until
it clicks into place.
Then attach the transparent part to the bowl by pressing lightly so that the edge
snaps onto the top of the bowl.
USE
Unroll the power cord completely.
Check that the tension in force in the country where you are, corresponds to
that indicated on the apparatus.
Connect the apparatus in a correct socket-outlet, (and connected to the ground
if the unit is Class I), to avoid any danger.
Disconnect the power source cable before any operation of cleaning of
maintenance and accessories assembly.
Never modify the appliance in anyway.
1. The unit should be placed on a stable horizontal surface near an electrical
outlet.
2. Make sure the cord is away from any water source.
3. Make sure the On / Off switch is in the
“
0
”
= (OFF) position.
4. Plug the unit into a grounded wall outlet.
5. Press the
“
1
”
(ON) button and let the unit run for 5 minutes for pre-heating.
Note : Do not touch the turntable => risk of burns.
6. After 5 minutes, press the On / Off button to "0".
7. Wait for the disc to stop completely, then spread about 10 g of sugar or 1 to 2
hard candies in the bowl.
Note : Use the spoon to arrange the sugar evenly throughout the cup.
8. Press the "1" (ON) button again. The disc will start to spin and heat.
