AUTOMATIC OSD FUNCTIONS
- 27 -
If the receiver is connected to a television with a
video cable from the monitor out jacks, the following
functions when used , will appear on-screen
automatically.
Test Tone:
In DOLBY DIGITAL, DOLBY PRO LOGIC
SURROUND, or 3 STEREO MODES, pressing the TEST
TONE button on the remote controller brings up a display
which allows you to adjust the relative volume of front,
rear and center speaker channels.
When the display comes up, each channel will begin to
blink in turn. When a channel is blinking, you can raise or
lower its volume using the up/down buttons. To turn the
display off, press ENTER or TEST TONE.
System Status:
When operating the system in DOLBY
DIGITAL, DOLBY PRO LOGIC, OR 3 STEREO you can
display the current status of your delay times and volume
settings, press any buttons on the remote controller
related to SURROUND, including SURROUND ON/OFF,
SURROUND MODE, LEVEL SELECT, SUB W ON/OFF,
SUB W LEVEL, CENTER/REAR DELAY or the up/down
buttons. This display will remain on screen for 7 seconds.
OSD
ON/OFF
TEST
TONE
NIGHT
MODE
MASTER
VOLUME
DIGITAL
INPUT
SUB W.
LEVEL
ON/OFF
MODE
SURROUND
SUB W.
R.LEVEL
CENTER
REAR
DELAY
R.LEVEL
SLEEP
MUTING
C.LEVEL
C.LEVEL
ON/OFF
Once this display appears, pressing the CENTER or REAR
DELAY TIME, or the CENTER or REAR LEVEL buttons will
enable you to change the function of the button pressed
using the right/left buttons. Pressing SUB W ON/OFF or
SUB W LEVEL will allow you to change the sub-woofer
setting by pressing the same button a second time.
Without input, the display will disappear in 7 seconds.
Sleep:
Pressing the SLEEP button on the remote control
brings up a display that allows you to select the amount of
time from 90 to 0 minutes after which the system will shut
itself off. Once the display appears, each time you press
the SLEEP button reduces the time in ten minute
increments. At zero, pressing the SLEEP button again
starts the sequence over at 90 minutes.
Without input, the display will disappear in 7 seconds.
Without input, the display will disappear in 7 seconds.
Volume:
Pressing the MASTER VOLUME button on the
remote control brings up a display that shows the receiver
volume selected.
OSD
ON/OFF
TEST
TONE
NIGHT
MODE
MASTER
VOLUME
DIGITAL
INPUT
SUB W.
LEVEL
ON/OFF
MODE
SURROUND
SUB W.
R.LEVEL
CENTER
REAR
DELAY
R.LEVEL
SLEEP
MUTING
C.LEVEL
C.LEVEL
ON/OFF
OSD
ON/OFF
TEST
TONE
NIGHT
MODE
MASTER
VOLUME
DIGITAL
INPUT
SUB W.
LEVEL
ON/OFF
MODE
SURROUND
SUB W.
R.LEVEL
CENTER
REAR
DELAY
R.LEVEL
SLEEP
MUTING
C.LEVEL
C.LEVEL
ON/OFF
