USER MANUAL
30
5.6 Alarm
In these section, you can configure the Motion Detection.
5.6.1 Motion
This menu allows you to configure motion parameters. The motion detection is pretty straight
forward, the WIRELESS NVR simply compares one frame to another. A sufficient amount of
difference is interpreted as motion. When the motion is detected, the system can be set to
automatically initiate recording. In this menu you can select the channels where you want the
motion detection recording to take place.
If you set the motion detection at a high sensitivity level (“8” is the most sensitive) then the
frequency of false alarm events increases. If the sensitivity level is too low (“1” is the least
sensitive), you might increase the risk that a significant motion event will not trigger the motion
detection to record.
Channel
: Select the channel you want to set the motion detection.
Enable
: Enable or disable the function.
Buzzer
:
The WIRELESS NVR can use its internal buzzer to emit an alarm tone. You can set the
buzzer duration in seconds when the motion is detected.
Sensitivity
: Set the sensitivity level.
