Techroutes TSR 2900-10, Руководство по установке оборудования

Страница: 9 / 18

TSR2900-10 Hardware Installation Manual
- 7

Each device on the cabinet gives off heat when it runs. Therefore, the sealed
cabinet must have the heat-discharge outlet and the cooling fan. Do not put the
devices too close, avoiding bad ventilation.

When you install the machine box at the open cabinet, prevent the frame of the
cabinet from blocking the airway of the machine box.

Ensure that nice ventilation is provided for the devices installed at the bottom of
the cabinet.

The clapboard separates exhaust gas and inflow air, and boost cool air to flow
in the machine box. The best location of the clapboard is decided by the air flow
mode in the machine box, which can be obtained through different location tests.
2.3.4 Power Requirements
Make sure that the power supply has nice grounding and the power at the input side
of the router is reliable. The voltage control can be installed if necessary.
Warning
：
If the power supply system does not have good grounding, or the input power disturbs
too much and excessive pulses exist, the error code rate of communication devices
increases and even the hardware system will be damaged.
2.4 Installation Tools and Device
The tools and devices to install the router are not provided by the router. You yourself
need to prepare them. The following are the tools and devices needed for the typical
installation of the router:

Screwdriver

Static armguard

Bolt

Ethernet cable

HUB or PC with Ethernet card

Control terminal

MODEM
Chapter 3 Installing TSR2900-10
Caution:
Only professionals are allowed to install or replace the devices.