While holding the elevator tight against the stabilizer, apply a strip of
clear
plastic tape (not included) to the top of the hinge line on both
sides of the
elevator.
Sand a 45º bevel into the left side of the leading edge of the
rudder.
Sand a 45º bevel into the bottom of the leading edge of
the two ailerons.
Use foam-friendly C/A to glue the carbon strips to A and
B to strengthen the wings
.
Use some tape to warp the carbon strips on A,B,C and D showed in
the picture to avoid the carbon falling off
.
Glue the wings with aileron to fuselage.
Notice
：
Measure from the tips
of the wing to the rear of
the fuselage. The measurements
must match from right
to left. If not, adjust the position of
the wing until both
measurements are equal.
Содержание Malibu-F3P
Страница 1: ......
