Version 5.0 DUT-E Installation Manual
© 2007-2011, JV Technoton 13 of 30
2.4 Cutting of the measuring part for the necessary tank
depth
In order to avoid the short circuit of the measuring part tubes caused by water or
electroconductive residues that are gathered on the bottom of the tank, there should be at
least 2 cm gap between the tube end of the DUT-E measuring part and the bottom of the
fuel tank.
ATTENTION!
For DUT-E A5, DUT-E A10, DUT-E F:
allowed to make cutting up to 30% without further
calibration;
For DUT-E 232, DUT-E 485:
allowed to make cutting up to 70% with further calibration.
ATTENTION!
DUT-E cutting should be done by means of hacksaw or with a pipe cutter of a
suitable diameter. Cutting edges should be thoroughly cleaned up and washed up with the
fuel.
Steps by DUT-E cutting:
a)
measure the depth from the mounting plate till the tank bottom (see Fig. 8);
Fig.8.
Measuring the depth of the fuel tank
