Supplementary Instructions TT-KS LT
1. General information on our TT-KS LT surface storage heaters
All the spatial requirements can be successfully achieved with one of our variety of electrical
surface storage heaters. TECHNOTHERM’s surface storage heaters can be used as main,
supplementary or transitional heaters in all rooms in a living area, apart from the exceptions listed
in the Safety Instructions. They are designed for continuous operation. All our products are
subjected to a comprehensive functional, security and quality inspection prior to their dispatch.
We guarantee you a constructive structure which complies with the currently applicable
international, European and German safety regulations. You can see this by our products’
labelling with well-known certification marks: “TÜV-GS”, “SLG GS”, “Keymark”, “CE”. Our heaters
are also assessed according to the internationally valid IEC regulations. The manufacture of our
heaters is permanently monitored by an officially accredited testing laboratory.
The TT-KS LT electrical storage heater is equipped with an integrated sensor which
continuously measures the surface temperature. When the pre-set surface temperature is
exceeded, the sensor interrupts the heating output.
2. Directions for setting the surface temperature
(Can only be done by an authorized technician)
At the factory, the Sensor is set at
60°C
. However, it is possible that the surface
temperature of your heater varies by a few degrees up or down. This is caused by
the heater’s ambience (mounting under window sills, special masonry etc.).
Using a simple tool, you can adjust the internal sensor according to your needs. Please
observe the following steps:
1) Remove the cover of your heating.
2) Insert a small slotted screwdriver from above through one of the central holes on the side
panel and turn the adjusting knob in the desired direction. (Side panel with power supply
and thermostat). You do
not
need need to unscrew the side panel!
Insert a screwdriver into the hole
•
Turn
clockwise
if you want to
increase the surface temperature!
•
Turn
counter- clockwise
if you want to
reduce the surface temperature!
2
Update
08/18
GB
