6
Edition: 02/17
Manual ISP-Design
Connecting the recipient (only with the "RH" models)
Press on the receiver for more than 3 seconds the button until the indicator light
begins to flash. Then attach the transmitter in configuration mode (see manual
transmitter). If the indicator light on the receiver stops flashing, the two
products are assigned.
Disconnect the receiver
To delete all associated products you press the receiver button for about 30
seconds until the indicator light flashes briefly. All channels are now deleted!
Technical data’s oft the receiver „RF“
• power supply 230 V, 50 Hz +/-10%
• protection class II
• consumption: 0,5 V
•
switching capacity
max.: 16 A 230 V
eff
Cos
φ
= 1
• radio frequency 868 MHz (Norm EN 300 220),
• radio range up to 300 m (outdoor), indoor up to 30 m, depending of
structural factors and electromagnetic
interference.
•
maximum number of recipients
: 8 units
• temperature range: -5°C to +50°C
• dimensions: 120 x 54 x 25 mm
• IP 44 - IK 04
Switching from X3D to X2D and vice versa:
X2D for TPF/TBF
X3D for TPF-Eco
1)
Before the changeover, the assignment to the thermostat must be cleared.
Press and hold for 30 seconds (1):
after 3 seconds, the LED flashes slowly.
after 7 seconds, the LED flashes quickly. Keep the receiver button pressed until both
LEDs flash.
Release the button (2).
GB
