2.
Unplug the cable from the telephone.
3.
Plug this cable into the back of the 911 Alert connector
labeled
LINE IN
5
4.
Plug one end of the supplied phone cable into the connector
labeled
TEL OUT
.
5.
Plug the other end into the wall telephone outlet from which
you unplugged the phone.
6.
Plug the AC power supply into the 911Alert connector
labeled
6V
.
7.
Plug the AC end into a 110-115V outlet.
Programming a non-911
Emergency Number
The transmitter recognizes when someone dials ‘911’. If your
area does not use 911 as the emergency number, or you want to
use another number to activate the strobe, you can program a
different number (up to 11 digits).
To program an additional number:
1.
Ensure that the transmitter is connected (see
Connecting the
Transmitter
above).
2.
On your phone keypad (receiver on the hook), press “##”
twice.
3.
Dial the emergency number you want to program, then
press “#” once.
!
!
!
!
"
Do not exceed 3 seconds between numbers when
programming the number into the transmitter.
This additional number (or
911
) now activates the strobe.
6
Testing the System
You can test the system without actually dialing 911 (or your
other programmed emergency number).
To test the system without calling 911, dial “
*
” before the
number.
For example,
1.
Dial
*
911
or
*
programmed number
The Strobe will start flashing without the call going
through.
2.
To turn the strobe off, dial
#
911
or
#
programmed
number
.
T E L O U T
L IN E IN
6 V
Cover Release
