EN.5
Remarks:
For better use of your weather station, place it at a location with open air circulation e.g.
close by an open window. Placing it at air-conditioned environment will affect its accuracy.
After your weather station is powered up, it will take around 24 hours to get stable. The
weather icons on the display give a reference to the next 6-12 hours weather conditions. It
may not match with the current weather condition outside.
TO SYNCHRONIZE YOUR CLOCK WITH MULTIPLE OUTDOOR SENSORS
Your wireless thermometer-clock is equipped with one outdoor sensor. You could purchase
second or third outdoor sensor to work with this thermometer-clock at the same time.
1. Press
/ CHANNEL (ALM On-
Off) once, the lowest line of the LCD shows “CH2” and
show “--“. Then press and hold / CHANNEL / ALM On-Off for 2 seconds,
until the
CH2 icon blinks, your weather station is searching for the signal of another outdoor
transmitter at Channel 2.
2. Slide open the battery door of your second transmitter, slide the switch to the middle
position marked with 2, then insert two AAA batteries into the battery compartment by
observing the c/- polarity. Replace the battery cover.
3. The outdoor temperature of your second transmitter will appear on the LCD together
with “CH2” icon within few seconds. If the data still does not appear, take out and
reinstall batteries to your second transmitter once.
4. To synchronize your weather station with a third outdoor sensor, repeat the same step
by choosing “CH3” on your weather station and select 3 on the switch on your third
transmitter.
TROUBLE SHOOTING
1. In case your wireless thermometer-clock shows irrelevant information or digits, it maybe
affected by electrostatic discharge or interferences from other devices. Press the
RESET button once. Your unit will be reset to default setting of time and calendar and
you need set time and calendar again.
2. In cas
e the outdoor temperature shows “--“ :
2.1) press
/ CHANNEL (ALM On-
Off) to view the correct channel i.e. “CH1” is your
default channel
2.2) If Outdoor temperature shows “CH1”, press and hold / CHANNEL (ALM ON-
OFF) for 2 seconds. The outdoor temperature should be displayed in around 1 minute.
2.3) if the above do not work, repeat 2.2), then bring in the outdoor sensor and take out
and reinstall batteries to your outdoor transmitter.
Remark:
If you observe a Low Battery icon on the lower left LCD, which means
your outdoor sensor is at low battery level, replace the batteries of your wireless transmitter
with fresh batteries.
SPECIFICATIONS
Indoor Temp. Range
-10°C to +50°C (+14.2°F to +122°F)
Outdoor Temp. Range
-50°C to + 70°C (-58°F to +158°F)
Out of Range Display
Temperature: HH.H / LL.L
Outdoor Temperature Interval
every 1 minute
Temperature Resolution
0.1°C
Alarm Duration
2 minutes
Transmission distance
up to 30 meters
