WQ 145
Solar Powered Alarm Desktop Clock
Instruction Manual
Introduction
This solar powered desktop clock comes with calendar, weekday display, and
temperature display. It is solar powered with optional backup DC batteries. The light
condition in most bright indoor spaces is sufficient to recharge the built-in rechargeable
batteries. Exposing the unit to direct sunlight is not suggested and it is not necessary.
(1) “SNOOZE / LIGHT” button
(2) “ALARM SET” button
(3) “MODE” button
(4) “+/12/24” button
(5) “-/C/F” button
(6) “ALARM ON/OFF” button
(7) Battery compartment
Getting started:
Toggle the “On/Off” switch located under the battery compartment (7) to turn on the clock,
Optional batteries installation
1. Open battery compartment (7) on the back of the unit. (see figure 2)
2. Install / replace with 2x “AAA” size batteries in the compartment. It is
recommended that only alkaline batteries are used.
3. Replace the battery compartment (7) on the back of the unit.
Batteries safety warnings:
1. Please read all instructions carefully before use.
2. Install batteries correctly by matching the polarities (+/-).
3. Always replace a complete set of batteries.
4. Never mix used and new batteries.
5. Remove exhausted batteries immediately.
6. Remove batteries when not in use.
7. Do not recharge and do not dispose of batteries in fire as the batteries may
explode.
8. Ensure batteries are stored away from metal objects as contact may cause a
short circuit.
9. Avoid exposing batteries to temperature or humidity extremes or direct sunlight.
10. Keep all batteries out of reach from children. They are a choking hazard.
11. Please retain packaging for future reference.
To set time manually:
1.
When the time is showing, press and hold “MODE” button (3) until the
