Technogym SYNCHRO Excite +, Руководство по обслуживанию и ремонту

Страница: 137 / 196

SYNCHRO : Service & maintenance manual - rev. 7.1
Page 7.39
Figure 7.11-9
Reassembly notes:
1. Reinsert the belt on the pulley.
2.
Place the 2 pillow blocks again on the shaft.
3.
Lock the left pillow block on the machine
frame.
4.
Push the left pillow block up against the shaft
ledge and tighten the grub screws
(a) and (b) .
5.
Lock the right pillow block on the machine
frame, so that the shaft is horizontal.
6.
Rotate the pulley as indicated by the arrows,
to align the right grub screws
(c) and (d) with
the left ones.
7.
Tighten the right grub screws.
ATTENTION: Screw the grub screws
indicated in the picture by the arrows,
which are fixing the bearings, keeping
them aligned on both the sides of the
shaft.
8. Place the belt on the pulley, leaving one race
free on the right side and one free on the left
side, as indicated by the yellow arrows in the
figure at the side.
Continued in following page...