Technogym BIOSTRENGTH LINE, Руководство по техническому обслуживанию

Страница: 577 / 646

BIOSTRENGTH LINE: Service & Maintenance manual - rev. 2.1
Page 8.3
To achieve this situation, you must adjust the value of the PLATE DISTANCE parameter as
described in the paragraph 9.2.6. “Distance between plates”. A specific weight is selected by
moving the weight stack selection system until it receives the number of pulses equal to the
configured value of the distance between plates.
8.1.3. W
EIGHT STACK MOTOR INERTIA
The plates are selected by moving the weight stack selection system, by switching the weight stack
motor on and off. When it is shut off, the motor continues moving for a minimal amount because of
inertia, although its ends are short-circuited; this distance may be identified by a limited number of
pulses.
To prevent this distance from losing control of the position over time, the parameter WEIGHT
STACK MOTOR INERTIA, which may be configured as described in the paragraph 9.2.4. “Weight
stack motor inertia”, allows you to define the advance motor shut off time so that the weight stack
selection system also takes into account the motor inertia when selecting the plates.