BIOCIRCUIT - BIOCIRCUIT FREE Pre-Installation Requirements
Rev. 6.0
- 15 -
PIR-00063-EN- Uncontrolled copy if printed
RUN ARTIS - TECHNICAL CHARACTERISTICS
Power Supply
200÷240Vac, 50/60Hz
Power Supply
100÷240Vac, 50/60Hz
Peak motor power
5800W (7.8Hp)
5800W (7.8Hp)
Speed 100 Vac power supply maxi
-
mum power input
-
0.8-25Km/h (0.5-15.5
mph) 1600VA
Speed 120 Vac power supply maxi
-
mum power input
-
0.8-25Km/h (0.5-15.5
mph) 2000VA
Speed 200-240 Vac power supply ma
-
ximum power input
0.8-25Km/h (0.5-15.5 mph)
2200VA
0.8-25Km/h (0.5-15.5
mph) 2200VA
Gradient
0-15%
0-15%
Noise Level
Less than 70 dB
Less than 70 dB
Protection rating
IP 20
IP 20
Tab. 8 - Run Artis - Technical Characteristics
4.2
RECOMMENDATION: RCD SWITCH TYPE F
In the sites with RCD Switches installed it is mandatory to have a RCD Switch
type F
for every
strength machine.
4.3 ELECTRICAL CONNECTION
Before connecting the product to the mains power supply, ensure that the electrical system speci
-
fications comply with current regulations. Check the mains power supply specifications on the
identification label - on the label affixed close to the main switch.
The wall socket must be located in a place where the plugging and unplugging can be
done easily and safely.
The power supply socket must be grounded. If not, a ground connection must be in
-
stalled by a qualified electrician before connecting the equipment to the electricity mains.
The plug must be connected to an appropriate socket that is properly installed and earthed in ac
-
cordance with all local codes and ordinances.
Improper connection of the earth wire may result in risk of electrical shock. Check
with a qualified electrician or maintenance operator if you are in doubt as to whether the
product is properly earthed. Do not modify the plug provided with the product; if it does not
fit the socket, have a suitable socket installed by a qualified electrician.
There must be a dedicated power supply line for each machine and Unity Self. Connection in series
via “Bridge” cable is not certified for BIOCIRCUIT and must not be realised.
The wall socket of the Unity Self must provide power of at least 800 watt and be used exclusively
for Unity Self.
