Technisonic Industries Limited TiL-91-DE/8.33, Инструкция по установке и эксплуатации

Страница: 13 / 32

3-2
(8) Set the SQUELCH control in the fully counter-clockwise (CCW) position.
(9) Set the VOLUME control in the 12 o'clock centre position.
(10) Set the AC POWER, External Battery (if connected) and transceiver ON/OFF switch to "ON".
(11) Verify that the FUSE BLOWN red LED on the transceiver is OFF.
(12) Verify that the POWER ON green LED on both the transceiver and Power Supply are ON.
(13) Proceed to operate in the transmit mode, paragraph 3.3 or operate in the receive mode,
paragraph 3.4 as required.
3.3 Transmitter Operation
To operate the transceiver in the transmit mode, proceed as follows:
(1) Hold the microphone in one hand, with the upper edge of the microphone as close as
possible to the upper lip.
NOTE
This technique activates the noise cancelling feature
of the microphone. The microphone is most effective
when sound is ½ inch (12.7 mm) or more away from
the microphone.
(3) Press and hold the PRESS-TO-TALK switch of the microphone during transmission.
(4) Ensure that the Tx ON amber LED is ON.
(5) Speak slowly and distinctly into the microphone using specified operating procedures during
transmission.
(6) When message is ended, release the PRESS-TO-TALK switch of the microphone.
(7) The transceiver is now operating in the receive mode.
(8) Verify that the Tx ON amber LED is OFF.
(9) Refer to Section 4 for Transceiver specific Operation and additional operating modes.