TechniSat EC 4004
20
>
set the second audio frequency and
>
then switch to stereo operation pressing M/ST.
The display responds to improper entries with "Err.".
When holding the
keys depressed, the frequency changes continuously, starting at 10 kHz
steps followed by 50 kHz increments, after 10 changes.
You can set the audio bandwidth and the deemphasis by pressing the SAT key repeatedly.
Satellites and their corresponding satellite types are listed in chapter 6.1, satellite types.
MEM
Press the
•
key to memorize your settings and, if necessary, enter a new channel number.
The deemphasis can also be set independent of the satellite type, but cannot be memorized.
DEEM
>
When pressing
repeatedly, you can cyclically switch between the deem-
phasis settings.
> In the adaptive setting the sound assessment is compatible to the WEGENER-
PANDA method.
>
Make sure that the right sound channel is selected.
5.2.3.3 MAC audio settings
Chapters 4.2.2 and 4.2.3 describe all possible MAC channel settings.
5.2.3.4 LNB voltage
LNB
With
you can switch cyclically between the following LNB voltages:
14 V, no modulation
18 V, no modulation
14 V, modulated with 22 kHz
18 V, modulated with 22 kHz
This allows you to control two V/H LNB's by using an adequate switch (for example MULTYSAT
switch).
*EC 4004 ENGL. 14.12.1999 9:59 Uhr Seite 20
