fig.2
Installation
Positioning the Appliance
Position the appliance in the desired location. The back should
rest against the wall, and the sides along the adjacent cabinets
or walls. The dishwasher is equipped with water supply and drain
hoses that can be positioned to the right or left to allow correct
installation.
Levelling the Appliance
Once the appliance is positioned, adjust the feet (screwing them
in or out) of level the dishwasher. The appliance should not be
inclined more than 2 degrees to ensure proper performance.
Cold Water Connection (only)
Connect the cold water supply hose to a threaded 3/4 bsp connector
and make sure that it is fastened tightly (see fig.1).
If the water pipes are new or have not been used for an extended
period of time, let the water run first, till it is clear and free of
impurities. Otherwise the water inlet filter may get blocked.
650KPa Pressure limiting Valve is required.
Attention:
The plastic hose support must be fastened to the wall to pre-
vent the drain hose from moving.
Electrical Connection
After making sure that the voltage and frequency in the home cor-
respond to those on the rating plate of the appliance (located on
the side of the stainless steel inner door) and that the electrical
system can cope with the maximum voltage on the rating plate,
insert thr plug into an earthed electrical socket.
Drain Hose Connection
Insert the drain hose into a drain pipe with a minimum diameter of
40mm, or let it run into the sink. Use the plastic support that comes
with the appliance (see fig .2) and ensure there are no tight bends
or kinks. The free end of the hose must be at a height between 40
and 100 cm and must not be immersed in water.
fig.1
.9.
MAX 100
MIN 40
DO NOT USE ADAPTORS OR EXTENSION LEADS.
