11
Turning on the Appliance
Starting a wash cycle...
Draw out the lower and upper basket, load the dishes and push them back. It is commended that loading
the lower basket first, than the upper one (see the section entitled “Loading the Dishwasher”).
Pour in the detergent (see the section entitled “Salt, Detergent and Rinse Aid”).
Insert the plug into the socket. The power supply is 220-240VAC 50 HZ, the specification of the socket is
10 A 250 VAC. Make sure that the water supply is turned on to full pressure.
1
2
3
4
5 If you want to select half washing, you should press Half washing button after selecting washing program, and the half
washing light will be on, then press the Start/Reset button to start.
If up to three program
, that indicates the machine is out of order
(page 20th "Error code"), please turn off the main power and water supply before calling a service.
lights fast blinking
NOTE:
A forgotten dish can be added any time before the detergent cup opens.
Open the door a little to stop the washing.
After the spray arms stop working, you can open the door
completely.
Add forgotten dishes.
Close the door, the dishwasher will run after
10 seconds.
4
3
2
1
It is dangerous to open the door when washing, because the hot water may scald you.
Open the door carefully. Hot steam may escape when the door is opened!
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around 15 minutes before removing
from the appliance.
Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In this way they will be cooler and
the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet inside. Empty the lower basket first and than the upper one. This will avoid water dripping
from the upper basket onto the dishes in the lower one.
NOTE:
NOTE:
NOTE:
When select 6 kinds of wash program: Press the programme button, the wash program will change as
follows direction
Intensive->heavy->Normal->Rinse->Rapid->Soak;
When a program is selected, the response light will light. Then press the Start/Reset button, the program
is running and the selected program light starts blinking..
Premise
You can modified the washing program, the dishwasher
:
has been running for a short time.
Otherwise, the detergent may have already been released, and the appliance may have already drained the
wash water. If this is the case, the detergent dispenser must be refilled(see the section entitled " Loading
the Detergent " ).
The program lights shows the state of the dishwasher:
a) A
--> stand by
b) One of the program lights on --> pause
c) One of the program lights blinking slowly --> run
d
Press Start/Reset Button more than three seconds the machine will be in stand by state , then you can change
the program to the desired cycle setting (see the section entitled " Starting a wash cycle. . . " ).
ll of the program lights cut of f
)some of the up three program lights fast blinking -->error
If you open the door during washing, then close the door, the machine will run after 10 seconds;
If you press the Start/Reset button to pause during washing, you should press the button again
to continue, the machine will run after 10 seconds.
If you
or open the door during washing, the program light will
stop blinking and the dishwasher will beep every minute to warn you unless you run it again.
press the Start/Reset button to pause
Содержание TDX6SS-3
Страница 1: ...TDX6SS 3 TDX6W 3...
