Top heating element
Temperature Reached
7. PROGRAMM AND FUNCTIONS
7.1 Time Setting
When the first use, DSP1 shows a flashing“0
：
00”.
Turn PT1 set hour clock, set hours later, click the PT1 set minutes, rotating PT1 set clock
minutes, then click on the PT1 confirmation.
7.2 Setting the current time
In standby state, press PT1 until DSP1 scintillation display has set the clock, repeat 7.1
operation modification clock
7.3 Selecting the oven function
In standby state, press the PT2, DP3 will light, turn PT2 to left and right to choose a mode.
Cooking
time symbol “
” and temperature reached symbol “
” light, The screen displays
30
：
00 and 180
℃
.
After pressing “PT1”,the appliance will switch to select roast time mode, turn PT1 to left and
right to select roast time ,89 hours 59 minutes can be set as maximum.
After pressing “PT1”,the appliance will switch to select temperature mode, turn PT1to left and
right to decrease or increase temperature, You can choose from 110
℃
to 250
℃
Press PT1 again after selecting roast time and temperature ,it will switch to select delay time
mode, the delay time symbol
“
” light(For further information about delay time setting see
point „Delay Time Setting‟)
After pressing PT2(start/pause key),the oven starts working, and baking time countdown
displays, the
symbol“
：
”always light, select functions symbol and heating up symbol is flashing.
7.4 Delay time
When PT1 is pressed to define a delayed start time the corresponding light
“
”starts to
blink. DSP1 shows the current time and DSP2 shows „AUTO‟. Turn PT1 to the right or left to
change the delayed start time. Press PT2 to validate the delayed start time.
DSP1 shows the delayed start time you set and DSP2 shows “AUTO”
Press PT2 for 3 seconds if you want to cancel the selected function.
7.5 Pause in the process of cooking
You can stop the cooking process at any time by pressing PT2, if you wish, at this time you
can:
Adjust cooking time, temperature and functions
Cancel the process by pressing PT2 for 3 seconds
Modifying Parameters
The operating parameters (time, temperature.) can only be modified when the cooking process
has been interrupted. Proceed as follows:
Turn PT2 to the right or left to change the function.
Press PT1 to activate the parameter modification mode
. “
” indicator starts to blink. Turn
PT1 to the right or left to change the remaining cooking duration
Press PT1 to validate and the next parameter light starts to blink. Proceed as described in
the active function chapter to modify the remaining parameters.
Press PT2 to continue the cooking process.
Buzzer will ring and DSP1 shows “END” after every functions stop, the buzzer will ring
