4
ADJUSTING THE VOLUME
GETTING STARTED
CONNECTING POWER
Check that the mains voltage marked on the rating plate
•
on the AC adapter is the same as the voltage in your
area.
Plug the cord from the AC adapter into the DC In jack.
•
Plug the AC adapter into an AC outlet and switch the
•
mains power on.
To increase the volume:
Press the
•
VOL+
button, holding until the volume level
is set.
To decrease the volume:
Press the
•
VOL-
button, holding until the volume level is
set.
When the volume is adjusted, the display will switch to show
the volume level set on a scale of 00 (min) to 32 (max).
STANDBY CONTROL
When switching your radio on for the first time:
Extend the telescopic aerial before switching on.
•
Switch on the radio.
•
This will ensure that the initial DAB scan detects all available
stations.
When switched on the radio will scan for all usable stations
and store them alphanumerically -1 Radio, 2 Radio, AA Radio,
AB Radio... The initial scan will take a few minutes. After the
scan, the number of stations found will be displayed, the
clock will be set, the radio will display the first station in the
sequence and begin playing.
SETTING THE CLOCK
SETTING THE CLOCK
The clock on your radio is automatically set when first used
from the time signal broadcast with DAB radio stations.
If you are in an area where there is no DAB radio signal, you
can set the clock manually.
To set the clock manually:
Set the radio to Standby.
•
Press and hold the ALARM button.
•
‘SET CLK’ will be displayed briefly, then the time will be
displayed. The hour digits will flash.
Press the
•
TUN+
or
TUN-
button to set the hour to the
correct time.
Press the
•
SELECT/NAV
button to confirm the setting.
The minutes digits will flash.
Repeat these two steps to set the minutes correctly, then
•
continue to set the year, month and day.
When you complete the day setting, the clock settings will be
saved.
NOTE: If the radio is tuned to a DAB station, manual time and
date settings will be erased and the time and date will be set
by the broadcast data.
0:00
DAB
>>>>>
33
NOTE: If no stations are found after the scan, switch the radio
off and move it to a location with a stronger signal. When
you switch the radio back on it will automatically repeat the
scan process.
SCANNING
You can run a scan for stations and add to the station list at
any time. This may be necessary if the initial scan was run in
a poor signal area, if new stations are available or if you move
to a different location.
Refer to the ‘SCANNING’ section on page 8 for more details
of scanning.
Scan progress
Stations found
To turn the radio on:
Press the
•
button.
The radio will switch on and tune to the last station used.
To turn the power off:
Press the
•
button.
The radio will switch off. The clock will continue to run whilst
mains power is connected.
FIRST TIME USE
Содержание DCR1301
Страница 1: ...Owner s Handbook DCR1301 DAB Clock Radio...
Страница 2: ......
