Maintenance
Cleaning
Clean the device with a clean dry cloth. If cleaning solution is required, apply a little cleaning alcohol to the cloth. Never use abrasive
solvents as these will damage the unit’s finish.
During normal use, dust may accumulate on the fan blades. To clean the fan blades, first unplug the unit and set the AC/OFF/DC
Power Selector and the Fan Power Switch (#s 12 and 15 on the components diagram respectively) to “OFF.” Then detach the fan’s
protective cover using the Front Fan Cover Release Lock (# 3 on the components diagram). With the unit off and the fan set to off,
clean the fan’s blades with a dry cloth. Never clean the fan’s blades when the device or the fan is set to on. Be sure to reattach the
fan’s protective cover when done.
Replacing the Battery
WARNING: The battery should only be replaced by an appropriately licensed professional.
Battery Specifications: Lead Acid Battery 6V/4.5AH
First unplug the unit and and set the AC/OFF/DC Power Selector (# 12 on the components diagram) to “OFF.” Then open the unit’s
cover by unscrewing the appropriate screws. Locate the battery and safely disconnect the wires ensuring nothing comes in contact
with any exposed power sources. Safely reconnect the wires to the new battery making sure the negative and positive terminals are
properly attached to their respective wires and that no exposed power sources come in contact with body parts or other objects. Insert
the battery into its compartment and reconnect the unit’s cover.
Disclaimers
The Bluetooth word mark and logos are registered trademarks owned by SIG, Inc. and any use of such marks by Technical Pro is under license. Other trademarks and
trade name are those of their respective owners.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
Federal Communications Commission Requirements
The equipment has been tested and found to comply with the limits for Class B Digital Device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction, may cause harmful interference to radio communication. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
●Reorient or relocate the receiving antenna.
●Increase the separation between the equipment and receiver.
●Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
●Consult the dealer or an experienced radio/TV technician for help.
THE CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE COULD VOID THE USER’S
AUTHORITY TO OPERATE THE EQUIPMENT.
FCC Radiation Exposure Statement
The equipment complies with FCC radiation exposure limits set forth for uncontrolled equipment and meets the FCC radio frequency (RF) Exposure Guidelines in
Supplement C to OET65. The equipment has very low levels of RF energy that it is deemed to comply without testing of specific absorption ratio (SAR).
FS1BT
5