100BASE-T1 MediaConverter NXP
User Manual
9
2
HARDWARE INTERFACES
2.1
Connectors
On the label on top of the device you can see an overview about all HW interfaces of
the 100BASE-T1 MediaConverter_NXP.
Figure 2-1: Label of 100BASE-T1 MediaConverter_NXP
2.1.1
Black MQS Connector
The pinning of the ECU connectors is listed on the label on top of the device as well.
(See
).
The connector color is black.
The power supply for the device is supplied by pin 1 (12 Volt) and pin 10 (Ground)
If you apply a voltage higher than 18 volts, the device will be damaged!
