Technibel K 60 D 066 Z, Инструкция по установке

Страница: 18 / 24

9.1.4 - START-UP
• Position the control box button on the desired operating mode.
• Check general installation operation (temperatures, outputs,...).
.
CAUTION:
In order for the automatic heating slope correction system operate at an optimum level, we recommend
that, when starting the installation, the system be operated in
Comfort
heating mode for 2 to 3 days without modifying
the ambient setpoint.
Proceed in the same manner if the correction coefficient was reset. See paragraph 8.1.5.
9.2 - MAINTENANCE
• Perform the following operations at least once per year (the frequency of operations depends on the installation and
operating conditions):
- Check the composition and condition of the coolant.
- Check operating points and setpoints.
- Check the safety devices.
- Dust the electrical box.
- Ensure that all electrical connections are properly tight.
- Check the ground connections.
- Verification of the hydraulic circuit (cleaning of the strainer filter and drip pan, water quality, purge, pressure, etc.).
- Verification of the supplementary valve.
• For the generator and the boiler, refer to the instructions specific to these devices.
18
GB
10 - ELECTRICAL DIAGRAM
A1
Heating control board
KA1 Supplementary heating authorisation auxiliary relay
Q1 Control circuit breaker 230 VAC
Component symbols
10 05 826 - 01
A1
4 3
12
L1
3
5 4
2 1
3 1 2
O2 O1
O3
C A B
Q1
6A
PE
KA1
KA1
230V T- T+ E2 E1
H3 H2 H1 A3
- D2 D1 + C R3 R2 R1 FP
A2 CC A1 1 3 42 S3 S2 CC S1
4 3 1 2 4 3 2 1 4 3 2 1 3 2 1
1 2 3 5 43 2 1 2 31 4 1 2 3 4 5
CN4 CN3 CN2 CN1
CN5 CN6 CN7 CN8
C
U N
U
N
230 V power supply
Boiler
alarm
HP
(Heat pump)
On / Of
f
Default
Boiler Circulating pump
Supplementary valve
Pilot wire
Supplementary
heating
Inlet
(T
eleinfo) Remote info
Inlet
Load shedding
BUS BUS
Outdoor sensor
Water return probe