Technibel CA 250 X5 TA Series, Руководство по эксплуатации

Страница: 13 / 122

Operation with the Remote Control Unit
(continued)
NOTE
•
Choose the best position in the room for the remote control unit,
which also acts as the sensor for room comfort and transmits the
operating instructions. Once you’ve found this best position, always
keep the remote control unit there.
•
This appliance has a built-in 3-minute time delay circuit to ensure
reliable operation. When the operation button is pressed, the
compressor will start running within three minutes. In the event of
power failure, the unit will stop. When the power is restored, the
unit will restart automatically after three minutes.
2. Adjusting the
Fan Speed
A. Automatic Simply set the FAN SPEED selector to the position.
A microcomputer in the air conditioner automatically controls the fan
speed when the
mode is selected. When the air conditioner starts
operating, the difference between the room temperature and the set
temperature is detected by the microcomputer which then automatically
switches the fan speed to the most suitable level.
Cooling mode:
When difference between
room temperature and set
temperature is
FAN SPEED
2 °C and over High
Between 2 °C and 1 °C Medium
Below 1 °C Low
NOTE
The above table assumes that the sensor on the remote control is being
used. If the sensor on the indoor unit is being used (the
indicator is
on), actual operation may differ slightly from the operation described in
the table.
(Refer to ‘‘A/C SENSOR button’’ on page 9.)
B. Manual If you want to adjust fan speed manually during operation, just set the
FAN SPEED selector as desired. [
, , or ]
3. Fan Only
If you want to circulate air without any temperature control, follow these
steps:
STEP 1: Press the MODE selector button to switch to the fan mode.
(
)
STEP 2: Press the ON/OFF operation button.
STEP 3: Press the FAN SPEED button to select the fan speed of your
choice (
, , or ).
ON I /OFF
MODE
FLAP
FAN SPEED
SELECT
HH TIMER
SELECT
MM
TIME SET
NIGHT
SETBACK
BATTERIES
ACL
A/C
SENSOR
OFF ON
CLOCK
STEP 1
STEP 3
STEP 2
13