BEFORE YOU START THE ASSEMBLY, PLEASE READ THE FOLLOWING TIPS AND WARNINGS.
❶
Do a quick inventory
to make sure the
package contains all
the parts and hardware
listed in the assembly
instructions.
❷
Missing, damaged and
defective parts can be
replaced at no cost to
you. Please refer to the
last pages on this manual.
❸
The replacement parts
service is limited to the
continental United States. If
you reside in Hawaii, Puerto
Rico, U.S. Dependencies or
other countries, please
contact the supplier from
where the unit was purchased.
❹
If during assembly you
find an issue or need
clarification, please contact
our Customer Service for
assistance. Please refer to
the last pages on this
manual.
❺
On each step read
the instructions and
analyze the illustrations
thoroughly before
proceeding to do the
assembly.
❽
Do not
overtighten or force
the screws as they
might break, strip,
damage the threads
of the holes or get
stuck inside the
part.
❻
Make sure you understand
which hardware will be used
on each step. Using the wrong
size of screw, bolt or pin might
strip the threads or cause
damage to the part in which it
is being used.
❼
To avoid
misalignments, always
leave the screws loose
and tighten them until all
pieces are positioned
correctly.
❾
Sometimes the laminate might cover partially or
entirely the hole on a panel. If there is no visible hole
for the screw, pass and press the tip of your finger
over the area where the hole should be located to
feel the indentation, and once found, carefully pierce
the laminate to reveal the hole underneath.
❿
If the hole seems too small for the screw, first
make sure you are using the correct size of screw
and that it’s been installed in the correct hole. If the
hole still appears to be too small, carefully pierce
the laminate to reveal the hole’s actual size.
P.
3
RTA-B003
P.
3
