Techni Mobili RTA-4985, Руководство по сборке

Страница: 11 / 21

STEP15
-------
Screws:
6x25mm x2
�
6x40mm
x4
l:1-)-))))
STEP16
STEP17
-------
Screws:
6x40mm
x4
rn-)-m>
First screw the smaller bolts K to the back end of the panel 4, then screw the longer
bolts Eon the sides as shown.
Attention: The Innermost
holes are for the wooden
pins of panels 1 and 2 in
next step.
P.10
r
, � X4 (For the 1st and 4th
-
holes on the sides)
Assemble the CPU panels 1 - 2 - 5 to the CPU bottom panel 4 as
shown and explained in page 5.
Troubleshoots:
Problem:
The panels don't come down flush and there is a gap.
Solution 1:
Review and make sure you installed the correct size of
bolts in the correct positions in step 15.
Solution
2: Make sure the cam locks on panels 1, 2 and 4 are
properly aligned to receive the bolts.
Problem:
The cam locks don't turn or turn less than half way.
Solution:
Remove the panels, align the cam locks and insert a
screwdriver in every hole, jiggling it a little to allow the cam lock to
align inside the panel.
Cam lock direction
First screw the bolts E to the
bottom face of the CPU top panel
6, then assemble the panel to
panels
1
and
2
as shown and as
explained in page 5.
�
: . I :
'
STEP18
Insert the metal pins 35 into the
set of holes of the side panels 1
and
2
according to your desired
height, then place the adjustable
panel 10 over the pins.
Cam lock direction
,
f9
x4
,,r·�...J