6
Power
Do not apply power to the fixture until power source is verified. Do not attempt to use
this fixture if it appears damaged. For protection against electric shock, fixture must be
connected to suitable earth ground. Make sure fixture is disconnected from power mains
before any service.
This fixture automatically adjusts to mains voltage and frequency 100-250vAC 50/60Hz. The
listed power rating is its average wattage under normal conditions. All fixtures must be powered
directly from a switched circuit. This fixture cannot be run on a rheostat or dimmer circuit even
if used solely for a 0% to 100% switching. Before applying power to a fixture, check that the
fixture’s input voltage matches the power source voltage. Consult a qualified electrician if there
are any concerns about proper connection to power.
Mounting
Always consult a qualified professional when rigging. Consider access for routine maintenance
when selecting a mounting position. This fixture may be mounted in any position provided there
is adequate room for movement and ventilation. Mount the fixture securely using the two
mounting holes provided on both sides of the base. This fixture features an adjustable base
which allows the panel to be tilted at different desired angles. Always keep cords out of the way,
thus preventing any trip hazards. Secure all cables properly. Do not mount where the fixture will
be exposed to heavy water fall, high humidity, extreme temperature changes or restricted
ventilation. Do not obstruct any of the heat sink vents.
Basic Reference
Adjustable Bracket/Knobs
Segmented LED Display
Push Button Controls
PowerCON Type
In/Thru
Safety Cable
Attachment Point
5 Pin XLR Data In/Thru
Fuse Holder
