TEK3-IMX6UL HARDWARE MANUAL
– VER 1.00 – JAN 25. 2019
Page
28
of
32
5. Mounting
This section describes the mounting procedures for the TEK3-IMX6UL. The material in area of the
mounting must provide sufficient strength for safe mounting of this device.
5.1. Surface Mounting
There are 4 mounting holes (M5) on the front side of the device required for surface mounting. Four M4 or
M5 screws with at least 8mm head-to-tip length are required to secure this device to the surface.
Top view:
1
2
3
4
5.2. DIN Mounting
The device can be mounted on a DIN rail by using a DIN-rail bracket. There are four mounting holes (M3)
on the rear side of the device required for DIN bracket mounting (30mm DIN rail standard). Secure the
DIN bracket to the back of this device by using two M3 screws with at least 5mm head-to-tip length.
Bottom view:
1
2
3
4
