6
Note:
The pictures are just advice. Depending on your car it can be
a different way.
License plate holder installed to
the trunk lid.
License plate holder installed to
the bumper.
6.
Remove the cover of the reverse light.
7.
The thin two-core cable is used for power supply and as a
switching signal when reverse gear is engaged. Connect the two
wires with the two contacts of your reversing light. To do this, you
need to know their polarity (measure or check the circuit diagram):
The red cable must be mounted on the positive pole of the
reversing light and the black cable on an earth contact.
8.
Install the tail light cover again.
Important:
This installation only shows the rear view when the
reverse gear is chosen. Then the rear view camera gets power and
the WiFi signal is transmitted. The connected Smartphone shows
the rear view via App.
Note:
If your 12V connection of the rear view camera has a
permanent plus the signal will be transmitted permanently.
This can
drain the car battery!
Because of this we do not recommend a permanent
connection.
If you want a permanent connection make sure it
linked with the ignition of the car!
