Technaxx TX-09, Руководство пользователя, Страница: 7 / 12

(D) Format: Clean all data in the memory card or the internal
memory. If you have inserted a memory card that only format the
memory.
Press the UP / DOWN Button to the
Format item.
Then press the OK Button.
Press
UP / DOWN Button to select No / Yes .
Press the OK Button.
Note: 1. All data will be lose and can’t restore. Make sure you have backup all data
in the hard disk or other storage device before format it.
Strong recommend to format the memory card or internal memory before reuse your
Camera which can make sure every data can be saved normally.
Test Mode
Before use the Camera make sure the PIR sensor
work normally. Test its sensitivity and a correct
detection zone for your purpose.
Slide the TEST / NORMAL switch to TEST.
Press the POWER Button and hold about
1 sec. to turn it on. Close the rear cover and
lock latches completely.
Slide the
Camera in its mount
then fix it where you want to monitor.
Walk back and forth in front of the Camera . The
red TEST LED will illuminate when the Camera’s
sensor has detected you. Using this method you
can accurately position your Camera as desired.
Note: This TEST LED does not illuminate in
Surveillance mode. Slide the TEST/NORMAL
switch back to NORMAL after test completely.