Technalogix TXF-500, Руководство по эксплуатации

Страница: 51 / 79

1
S
af
eg
ua
rds
2
T
e
rms
a
n
d
W
ar
rant
y
3
P
ri
nc
ipl
e o
f
O
pe
rat
ion
4
Ins
tal
lat
io
n
5
O
pe
rat
ion
6
C
ont
rol
S
y
s
te
m
7
R
F
C
om
pon
en
ts
7
R
F
C
om
pon
en
ts
9
M
ai
n
te
nan
c
e
10
T
roubl
es
h
oo
ti
ng
Web Interface
To access the Technalogix Adrenaline Web Interface, a series of four simple
steps are required:
1. Connect power amplifier/transmitter to your network/PC
2. Open web browser for monitor and control
3. Optimize user parameters
The following pages will describe each step in detail. Descriptions specific to the
user’s computer, router, or network setup are limited due to the differences in the
multitude of networking equipment.
1. Connect Power Amplifier/Transmitter to your Network/PC
Connect an Ethernet cable from the RJ45 port (labelled ETH / SNMP – use
bottom connector) on the back panel of the power amplifier or transmitter to
your network’s Ethernet connection. Most new computers can do this with a
standard Ethernet cable but older network cards may require a crossover
Ethernet cable.
If preferred in place of the touch screen, a computer can be plugged directly
into the Ethernet port on the power amplifier/transmitter to directly access the
on-board web interface.
Turn on the power amplifier or transmitter to establish communication
between the power amplifier and the network.
The Adrenaline control system in the power amplifier or transmitter will source
an internal IP from your router or you can set this manually (see Optimize
User Parameter section).