Techly IDATA EXT-E70POED, Руководство пользователя

Страница: 11 / 14

HDMI EXTENDER OVER CAT.6/7 CABLE WITH EDID
11
EN EN
InstaLLatIon ProcEdurEs
How to make a Cat6 network cable?
Follow the standard of EIA-568:
1-Orange/white 2-Orange 3-Green/white
4-Blue 5-Blue/white 6-Green
7-Brown/white 8-Brown
connEctIon InstructIon
1) Connect source device to transmitter unit (TX) and display device to receiver unit (RX) via HDM
cables.
2) Connect transmitter unit (TX) and receiver unit (RX) via network cables (CAT6/CAT6A/CAT7)
3) Plug the power supply to transmitter unit only, each unit will power up then initialize itself, this
HDMI extender works.
HDMI OUT
HDMI EX TENDER
TX
HDMI EX TENDER
RX
C A T 6 / 6 A / 7 C a b le
HDMI display
D V D
HDMI OUT
HDMI display
NOTE
It is recommended to use a length range within 15~40m network cable. If the CAT6 cable is too short,
there may be no display output because the signal is too strong. If the CAT6 cable is too long, the
output may be with poor quality.
Ir usEr guIdE
1) IR blaster extension cable should plug in the IR OUT port of TX (Sender) of HDMI extender and the
IR receiver extension cable should in the IR IN port of the RX (Receiver)
2) The emitter of the IR blaster should as close as possible to the IR receiver window of the signal
source device.
3) Using the IR remote controller of the signal source device towards the IR receiver (connected to
the receiver), to remote control source media playback.