Techly IDATA EXT-E704K2, Руководство пользователя

Страница: 12 / 16

12
EN
HDMI 2.0 EXTENDER OVER CAT.6/7 CABLE 4K
InstaLLatIon ProcEdurEs
Follow the standard of EIA-568:
1-Orange/white 2-Orange 3-Green/white
4-Blue 5-Blue/white 6-Green
7-Brown/white 8-Brown
connEctIon
(NOTE): Power from the transmitter unit
Connection instruction:
1) Connect source device to transmitter unit (TX) and display device to receiver unit (RX) via HDMI
cables.
2) Connect transmitter unit (TX) and receiver unit (RX) via network cables (CAT6/CAT6A/CAT7)
3) Plug the power supply to transmitter unit only, each unit will power up then initialize itself, when
connection between TX and RX unit is built, the RX unit will read the EDID or the connected display
device, and sends it back to the TX unit through the network cable, then source can accept and
read the EDID from TX unit, the source can then cater its output to send only resolutions and
features that are compatible with the attached display device.
4) After connecting with the power supply, the RX unit will detect the EDID of the display/TV, and then
send the EDID information back to the TX unit, so the source device would feed the most suitable
format of the HDMI signal to the connected display/TV. However, if the EDID of the display/TV
is damaged or it cannot be detected correctly, then the source device would feed HDMI signal
according to the built-in EDID of the HDMI extender.
(NOTE): It is recommended to use a length range within 15~50m network cable. If the Cat6 cable is
too short, there may be no display output because of the signal is too strong. If the Cat6 cable is too
long, the output may be with poor quality.