TECHFASS MREM 79, Руководство пользователя

Страница: 13 / 19

Page 13
6.7 Programming mode
The module enters programming mode by reading one of the two programming cards
(cards “ + ” and “ - “). The programming mode cannot be entered while the module is in
hardware address setting mode (for modules with HW address setting via the
communication line). The module’s functionality in programming mode can be seen in
pictures 4 a-d .
It is not possible to use time schedules when inserting cards in programming mode,
therefore cards are always valid.
6.7.1 Inserting cards into the reader’s memory
Follow these steps for inserting cards into the reader module’s memory:
Step 1 Step 2 Step 3
Read the programming card
for
inserting : the reader goes
into programming mode .
One by one, read the cards
which are to be granted
access. About 15 seconds after
inserting the last card the
reader module goes back
into
standard operating
mode .
Pic.4 a): Inserting cards
6.7.2 Deleting cards from the reader’s memory
For deleting the cards from the reader module’s memory use following steps:
Step 1 Step 2 Step 3
Read the programming card
for
deleting : the reader goes
into programming mode .
One by one, read the cards
which are to have their
access revoked. About 15 seconds after
deleting the last card the
reader module goes back
into
standard operating
mode .
Pic.4 b): Deleting cards