TECHCON SYSTEMS TS1251, Руководство пользователя

Страница: 13 / 17

Page 13
6.0 CLEANING INSTRUCTIONS-DISPENSER
WARNING: Read the material safety data sheets for special precautions for the specific material
being dispensed. Wear protective safety equipment in the material safety data sheets.
NOTE: When using solvents, it is essential that precautionary measurers for handling such materials be
observed. Eye protection is required during this operation.
NOTE: • Use de-greaser/cleaner (such as “Westley’s Clear Magic”) to clean plastic or glass reservoir.
• Soap or other cleaners may react with CA vapor and cause clouding on reservoir walls.
• Uncured adhesive on other surfaces may be cleaned up with Acetone, Methyl Ethyl Ketone or
Nitromethane. Remove cured adhesive with Nitromethane. Acetone or Methyl Ethyl Ketone works
slowly on Cured Adhesive. Do not use on plastic reservoir.
• Adhesive may be stored in unused adhesive dispenser for 72 hours. If unused for 72 hours or more,
dispenser must be cleaned and adhesive removed.
• Before cleaning dispenser all adhesive in dispense tube and dispensing device must be drained back
into the adhesive bottle.
1. Remove Needle from dispensing device. Follow Instructions Notes 1 through 5, as referred to in Section 5.0
Adhesive Supply Replacement.
2. To remove and recap adhesive bottle:
a. Carefully loosen Dip Tube from inside Pressure Reservoir.
b. Carefully remove Bottle from Pressure Dispenser. Discard Dip Tube and empty properly. Replace Bottle
Cap to save usable adhesive.
WARNING: When using flammable solvents, extinguish all sources of ignition in the immediate work area and
observe proper precautionary measures for handling the material.
CAUTION: Never pour solvents directly into reservoir.
3. To clean dispenser:
WARNING: Eye protection required for this operation.
a. Pour a suitable cyanoacrylate cleaner into a polyethylene or metal container and place in pressure
reservoir.
b. Install Dip Tube and close Dispenser Lid.
c. Hand tighten Lid Knob.
d. Hold dispense device: (optional Pen or Valve) over disposable container.
WARNING: When using solvents, it is essential that precautionary measures for handling such materials be
observed. Always use low air pressure when using solvent in the unit. Do not direct pen in direction of
yourself or others. Do not allow solvent to contact printed matter on the dispenser.