TEC TDW12WA, Руководство пользователя

Страница: 18 / 26

17
POWER CONNECTION (CONT.)
POWER CONNECTION - GROUNDING
WATER CONNECTION
CHECK DISHWASHER IS PROPERLY GROUNDED BEFORE USE
Ensure the voltage and frequency of the power being supplied corresponds to
those on the rating plate. Only insert the plug into an electrical socket which is earthed
properly. This dishwasher is designed to operate on a single phase power supply within a
voltage range of 220~240V/50Hz. If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly quali
fi ed ed persons in order to avoid a
hazard.
This appliance must be earthed. In the event of a malfunction or breakdown, earthing will
reduce the risk of electric shock. This appliance is equipped with a power cord with an
equipment-earthing conductor and an earthing plug. The plug must be inserted into an
appropriate outlet that is installed and earthed in accordance with local standards and
requirements.
CONNECTING THE SAFETY SUPPLY HOSE (AQUA-STOP)
The appliance must be connected to the water mains using a new
hose set. An old hose set should not be reused.
Water pressure must be between 0.04 MPa and 1 MPa.
If the pressure is below the minimum requirement, please consult your
local water supplier, authorised plumber or TECO service department
• Improper connection of the equipment earthing conductor may increase the risk of an
electric shock.
• Check with a quali
fi ed electrician or TECO service if you have any doubt about the
electrical safety of power source or power plug.
• Do not modify the plug provided with the appliance. If the plug does not
fi t properly in the
outlet, please consult a quali fi ed electrician.
WARNING
Fig.18
Pull the Aqua-stop completely out from storage compartment located at rear of
the dishwasher.
Tighten the screws of the Aqua-stop hose to the faucet with 19mm (3/4inch)
thread.
Turn on the water to full before starting the dishwasher.
Step 1
Step 2
Step 3