2. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
EO18-12010
2.1 Installing the Hard Disk Drive (HDD)
2- 2
2.1 Installing the Hard Disk Drive (HDD)
CAUTION!
1. For the specification of an HDD to be installed, please refer to the POS Optional Device (Document
No. EO21-12001), POS OPTIONAL DEVICE BASIC SPECIFICATION.
2. Please use TOSHIBA TEC approved HDDs. Failure to do this may cause an error.
Installation procedure for the first HDD is shown below.
•
Required Parts
The following part is required to install an HDD.
HDD Unit (locally procured)
HDD Fixing Screw M-3x3 (8 pcs.)
(
NOTE
)
NOTE: This is an accessory part of the POS terminal.
•
Installation Procedure
1)
Remove the two Rubber Caps from the Rear Cover.
2)
Remove the two screws then remove the Rear Cover.
Rubber Cap
Rubber Cap
and
DSM-4x10 Screw
Rear Cover
