TEBO AURA, Руководство пользователя

Страница: 18 / 21

33 32
Method of usage Method of usage
3
3. Firstly, insert the rotating inner sleeve and the rotating outer sleeve into the left
and right rotation shafts of the legrest (Note: The large step must face inward)
(Figure 3).
4. Then remove the rotation shaft cover supporting the legrest on the left and right
frames of the massage chair (Figure 4).
4
1.First of all, cut the connection wire and the air pipe tie fixed on the steel pipe
(Figure 1).
2.Connect the connection wire and the air pipe leading from the lower end of the
backrest to the legrest connectors. Confirm whether butt connection is OK. Then
insert the butt connection wire and air pipe into the bottom of the frame from the
lower hole of the backrest. Pay attention to avoiding any air pipe bending during
insertion (Figure 2).
1 2
5 6
5.Next, hang the legrest (left and right rotation shafts) into the rotation shaft cover
supporting such frames simultaneously (Figure 5).
6.Place the rotation shaft cover. Press the rotating outer sleeve of the legrest. Then
tighten the rotation shaft cover supporting the legrest with two M5×14 black zinc
environmentally-friendly hexagonal socket head screws and a 6×12×1.5 black
zinc environmentally-friendly flat pad by the supplied 4# hex wrench (Figure 6).
7. After the screws are tightened, hook the groove at the back end of the legrest
cover to the hinge pin. Then press down the front end of the legrest cover to make
it completely parallel to the rotation shaft cover. Hook the convex point at the side
of the legrest cover to the hole at the side of the legrest hook. Finally, the legrest
is installed (Figure 7)
7
VII. Installation Instructions for Legrest