Tebas INVERTER S, Руководство пользователя

Страница: 6 / 14

- 6 -
Hydraulic connections
The heat pump should be connected to the filter system via a 3-valve bypass. A bypass must be installed after the
pump and the filter. These valves make it possible to regulate the flow of water passing through the heat pump as well
as to completely disconnect the pump for maintenance, without the need to shut off the flow of filtered water.
If the system is equipped with water treatment devices (chlorine or bromine feeder, chlorine generator for salt water,
other devices), a bypass shall be installed upstream of these devices with a non-return valve between the bypass and
the treatment devices.
The water inlet and outlet are adapted for connection to a rigid pressure water pipeline made of PVC (in the case of
swimming pools), with a diameter of Ø50, directly glued to the fittings included in the set.
The water inlet pipe must be connected to the connection marked with the symbol:
The water discharge pipe must be connected to the connection marked with the symbol:
The water pipes must be fixed to the floor or walls so that the heat pump does not bear the weight of the water in the
system.
Do not use clamps or other devices to tighten the connections - hand tightening is sufficient.
Electrical connections
The supply voltage and current values must correspond to those indicated on the heat pump. The dimensions of the
connection cables must correspond to the device power and meet the installation requirements.
Model
Power
Security
Maximum cable length * in diameter:
2,5 mm² 4 mm² 6 mm² 10 mm²
TEBAS
INVERTER S
3G 230 V 16 A 25 m 35 m 45 m 80 m
TEBAS
INVERTER M
3G 230 V 20 A - 30 m 40 m 70 m
* Maksymalna długość kabla od pompy ciepła do zabezpieczenia prądowego.
The above figures are only approximate - consult an electrician to determine the exact figures for your
specific pool.
The power supply system must be equipped with grounding and differential protection.