4
2. GENERAL INFORMATION
National Standards, European Standards, local regulations, construction
regulations, fire protection and safety regulations must be observed.
During the installation, one must contact a person who is authorized for the
chimney. The authorized person shall check the shape of the chimney connection
of the product in the prescribed directions. In addition, the product installation
and installation connection must be made by an authorized person. Before
installing the stove, the lifting capacity of the installation ground should be
checked whether it is resistant for the stove. In case of insufficient load resistance
or low lifting capacity, suitable precautions must be taken (eg put a stove lifting
plate).
3. SAFETY
THE VENTILATION CONDITIONS WHERE THE PRODUCT WILL BE INSTALLED
AND THE PROTECTION AGAINST FREEZING MUST BE TAKEN INTO
CONSIDERATION.
All the required standard examinations are tested for the product. The predicted
parameters associated with combustion efficiency and exhaust gas emissions are
observed. The stove type described in this manual has been tested according to the
BA 1, DIN 1881 EN13240 standards, by an approved agency.
Combustion chamber cover should be opened only to load the fuel. To avoid
hazards, the combustion chamber must be closed. For the efficient operation of
the stove, there must be minimum of fresh air flow in the room where it is
installed.
CAUTION! The stove can operate in conjunction with the existing multiple
flue systems. This should not be an aspirator, ventilator etc.
The combustion of combustible materials causes heat energy to heat the stove
surfaces (doors, door handles, flame monitor cover, side walls, front wall). These
parts should not be touched without heat-protective gloves.
CAUTION! Since the stove top surface might be hot, please do not put
combustible materials on it.
