Teamline 5250
Page 11
Connecting Teamline 5250 to peripherals
Mounting Pronto
The supplied bracket can be used to mount Pronto to a surface using screws,
ties (such as cable ties or Velcro), or adhesive mounting pads. Remove Pronto
from the bracket to access the screw holes and slots for ties:
Connecting presentation sources
Presentation sources can be connected to
Computer In 1
and/or
Computer
In 2
on the rear of the Teamline system to display content locally on room
displays and to share content during meetings. It is recommended that you
leave a cable within easy access on the meeting room table for this purpose.
A selection of adapters are supplied that can be used with the DVI-I to DVI-I
cable if the video output on the presentation source is not DVI-I (for example,
VGA, HDMI, DVI-D.)
To send audio from a presentation source, connect the audio out on the
device to the audio
Line In
on the system. Otherwise, participants will not
receive audio from the device.
Extending cables
For information about supported cable extenders and cable information, see
Cable recommendations for room systems
.
Connecting power
Using the supplied power cable, connect the IEC mains power connector on
the rear of the system to the mains power.
Содержание 5250
Страница 1: ...Teamline 5250 Installation Guide...
