Team SILK SX28-72, Инструкция по эксплуатации

Страница: 40 / 93

SX28-72 Flange Facing Machine
39
required reposition the weights or add additional weights as necessary. Keep
checking until satisfied with the balance.
Fig. 22 Main and secondary counter balance plates with weights
WARNING: WHEN SETTING UP THE MACHINE ON A VERTICAL FLANGE THE
LIFTING CHAIN SHOULD BE LEFT ON UNTIL THE MACHINE IS FULLY
SECURED.
CAUTION: CARE MUST BE TAKEN TO ENSURE THAT THE LIFTING CHAIN
DOES NOT OBSTRUCT THE ROTATION OF THE MACHINE DURING THE
INSTALLATION.
12. Level the machine if necessary - i.e., parallel to the flange (refer to section 5.2.4,
paragraph 4).
When running, the following symptoms indicate that the machine is out of balance:
- Uneven arm rotation (erratic movement) this must be rectified immediately
as this may cause damage to the drive system.
- The arm or balance weights make the machine race as it goes past the 12
o'clock position i.e., the tone of the motors will change.
CAUTIONS: TO PREVENT DAMAGE TO THE MACHINE IT IS ESSENTIAL THAT
IT IS ACCURATELY BALANCED.
WHEN LIFTING AND POSITIONING THE MAIN COUNTERBALANCE WEIGHT
ATTACH THE SUPPLIED LIFTING LUG TO THE THREADED HOLE IN THE
WEIGHT AND USE A MECHANICAL LIFT.
BEFORE OPERATING RECHECK THAT THE BALANCING WEIGHTS AND
PLATES ARE FULLY SECURE ON THE MACHINE.
The flange facing machine is now installed and ready for operation (see 5.3).
Secondary
counter balance
plate with
weights
Primary counter
balance plate
with weights