v��
Power Switch/RX02-1
User Guide/Warranty
Thank you for choosing EZCon
®
Power
Switch RX02-1.
This Quick Instruction Manual explains the
basic installation and using procedures. For
the introduction of detailed product installa-
tion and troubleshooting, please visit the
official website at www.teamyoung.com.tw
for downloading.
●
The product complies with NCC Administrative Regula-
tions on Low Power Radio Waves Radiated Devices
：
Article 12
：
Without permission granted by the NCC,
any company, enterprise, or user is not allowed to
change frequency, enhance transmitting power or alter
original characteristic as well as performance to an
approved low power radio-frequency devices.
Article 14
：
The low power radio-frequency devices
shall not influence aircraft security and interfere legal
communications; If found, the user shall cease operating
immediately until no interference is achieved.
Precautions for safe use
Package contains
Power Switch RX02-1
Quick Instruction Manual
Screw * 2
The said legal communications means radio communi-
cations is operated in compliance with the Telecommu-
nications Act. The low power radio-frequency devices
must be susceptible with the interference from legal
communications or ISM radio wave radiated devices.
2
Plug the live(L) wire & naught(N) wire of supply mains
into the “IN” ports of Power Switch RX02-1, and plug the
live(L) wire & naught(N) wire of electrical appliance into
the “OUT” ports of Power Switch RX02-1 respectively.
• If the indicator light of Power Switch RX02-1 displays red,
the supply wire is properly connected.
• If the indicator light flashes red and green by turns, it
means that the connected electrical load exceeds the
rated OCP. Please turn off the electrical appliance and
notify the electricians to check.
• When the Power Switch RX02-1 outputs power, the
indicator light on the Power Switch RX02-1 will displays
green.
• The mounting base of product is pre-fixed with screw to
the back of Power Switch RX02-1. Please remove this
fixing screw to detach the mounting base for installation.
* If the information of RoHS Compliance Declaration is required, please visit our
website at www.teamyoung.com.tw .
How to Set up RX02-1
1
Confirm that the Power Switch RX02-1 is not connected
to supply mains, and its indicator light should not be
on at this stage. Use the USB cable to connect the
smart remote controller TX-RC-1 (Type A transmitting
terminal) and the corresponding Power Switch RX02-1
(MICRO-B receiving terminal) as shown below. The
indicator light in the Power Switch will turn red under
correct connection. Then select the control point of
Power Switch RX02-1. Long press “SET” button of
the smart remote controller TX-RC-1 to enter into
setting mode. Select the RX burning mode, press “ON”
button to confirm (or use hotkey: Press “SET” button
+ Down direction button). The setting program will
start automatically. When the setting is completed, the
screen of remote controller will display success and
return to the layout menu.
●
The Power Switch RX02-1 is recommended to be
installed by a professional electrician.
●
Indication of safety signs: if the recommended precau-
tions and safe operating method are not followed, it
may cause personal injury or equipment damage.
●
To avoid the danger of electric arc to user and damage
of electrical switch contact, please do not plug or unplug
powered-on RX products.
●
Notice for use : WARNING! Dangerous voltage!
Type-A-female connector
Micro-B connector
Dimming control switch
USB port Micro-B connector
“OUT” ports of electrical appliance
“IN” ports of supply mains
Indicator light
