Visit
www.modelflight.com.au
for more information and spare parts online.
Mini-T Pro Trouble Shooting Guide
Doesn’t operate
Battery not charged or plugged in
Charge battery / plug-in
No crystal in receiver
Check and replace if neces-
sary
No crystal in transmitter
Check and replace if neces-
sary
Receiver switch not “on”
Turn on receiver switch
Transmitter not “on” or low battery
Turn on / replace batteries
Motor runs but rear
Pinion not meshing with spur gear
Adjust pinion/spur mesh
wheels don’t move
Pinion spinning on motor shaft
replace pinion gear on motor
Slipper too loose
Check & adjust slipper
Differential slipping
Adjust / check differential
Drive pin in axle missing
Check & replace
Steering doesn’t work
Servo plug not in receiver
Check if plug in / all the way
Servo damaged
Replace or repair servo
Won’t turn one direction
Servo gears damaged
Replace servo gears
Motor doesn’t run
Motor plugs loose
Plug-in completely
Motor wire broken
Repair or replace as needed
ESC damaged
Check with manufacture
ESC gets hot
Motor over geared
Put smaller pinion on motor
Driveline bound up
Check wheels & trans for
binds
Poor run time and/or
Batteries weak or low
Check / replace battery pack
sluggish acceleration
Ni-Cad pack not fully charged
Recharge
Charger not allowing full charge
Try another charger/power
source
Slipper slipping too much
Check/adjust slipper & diff
Differential slipping
Tighten immediately
Motor worn out
Replace motor
Driveline bound up
Check wheels & trans for
binds
Poor range/glitches
Transmitter battery low
Check & replace as neces-
sary
Transmitter antenna loose
Check & tighten
Battery low in truck
Replace or recharge
Loose plugs or wires
Check motor and power
plugs
Slipper won’t adjust
Drive pin missing in shaft
Replace drive pin
Slipper pads worn out
Replace & adjust slipper
